Tom builds a metal wood stove to heat his shop.

Tom welds up a simple pizza oven fire box.

Tom brings an old weather vane back to life.

Tom shared this tip on building metal table legs.

Tom builds a septic truck strainer.

Tom receives an email on his Aluminum Cutting article…

Tom explains how to build metal handrail for a handicap ramp.

Tom welds steel posts and beams for a tornado room for a new construction home.

Tom helps weld up a large steel church steeple.

Tom fabricates a dry diving board for the local diving club.

Tom explains how beautiful metal table tops are finished.

Tom reviews tips on securing a metal building frame during construction.

Removing metal strap from the 20/20 Compact Bender, after it has been bent with the right angle attachment, takes a couple of easy steps. It is not necessary to remove the front hitch pins and disrupt your set up, especially if you have more than one metal strap to bend. In this video Tom explains [...]

Tom’s brother, Jim, purchased a new Kubota LA 854 tractor last spring. He brought it down to the shop so Tom could build and weld on a few accessories before using it. Tom fabricated a hook and chain holder for the front end loader. The holder is made out of half inch hot rolled steel [...]

Tom was asked to build a small trailer frame for a do it your-selfer who wants to build his own tear drop trailer…

It is that time of year again when our attention turns to the outdoors and the curb appeal of our homes. One easy way to give your front porch a quick face lift is to add or replace an outdoor stair rail.

An article and video on how Tom takes an inexpensive surplus purchase and turns it into something useful around the house and shop.

Tom explains the difference between a pop rivet and a drive rivet.

There is lots to observe at this years Winter Olympic games. One fabrication blog takes on the unique metal fireplace screed seen on NBC’s Today Show…

Tom uses a compact bender to fabricate metal handles.